Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995ASTRO VAN CARGO, RWDREPAIR AND DIAGNOSISBODY & FRAMEMIRRORS - POWERCOMPONENT LOCATIONS
1995 Chevrolet Astro Van Cargo, RWD
Component Locations
1995 Chevrolet Astro Van Cargo, RWDSECTION Component Locations
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Convenience Center | Behind Left Side Of Instrument Panel. See Fig 1 . |
| Fuse Block | Behind Left Side Of Instrument Panel. See Fig 1 . |
| Power Mirror Motor (Left) | Inside Left Mirror Housing. |
| Power Mirror Motor (Right) | Inside Right Mirror Housing. |
| Power Mirror Switch | Center Of Instrument Panel. See Fig 1 . |
| C224 (In-Line Fuse Amp) | Behind Left Side of Instrument Panel, Near Fuse Block. See Fig 1 . |
| C248 | Behind Left side Of Instrument Panel, At Fuse Block. See Fig 1 . |
| C284 | Below Right Side Of Instrument Panel, At Right Shroud. See Fig 2 . |
| C285 | Below Left Side Of Instrument Panel. At Left Shroud. See Fig 2 . |
| P225 | Left A-Pillar. See Fig 2 . |
| P226 | Right A-Pillar. See Fig 2 . |
| P520 | At Left A-Pillar. See Fig 3 . |
| P620 | At Right A-Pillar. See Fig 3 . |
| S252 | In Crossbody Harness, Left Side Of Instrument Panel. See Fig 2 . |
| S253 | In Crossbody Harness, Left Side Of Instrument Panel. See Fig 2 . |
| S254 | In Crossbody Harness, Left Side Of Instrument Panel. See Fig 2 . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.