Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995ASTRO VAN CARGO, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONFRONT SUSPENSIONSUSPENSION - FRONT (2WD)REMOVAL & INSTALLATIONUPPER CONTROL ARMINSTALLATION
1995 Chevrolet Astro Van Cargo, RWD
Upper Control Arm: Installation
1995 Chevrolet Astro Van Cargo, RWDSECTION Installation
- To install, reverse removal procedure. Ensure holes in upper control arm shaft align with holes in frame. Ensure alignment shims are installed in original position.
- Tighten bolts and nuts to specification. See the TORQUE SPECIFICATIONS table. Lower vehicle. Check wheel alignment. See the WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in the WHEEL ALIGNMENT section.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.