Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1994LUMINA BASEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - TESTS W/CODES - 3.1LECM/PCM CODE CHARTSCODE 72, VSSNOTES
1994 Chevrolet Lumina Base
Code 72, VSS: Notes
1994 Chevrolet Lumina BaseSECTION Notes
Speed sensor is a PM generator located on transmission output shaft.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- Disable TC system (if equipped) when performing this step. Whenever ignition is cycled off and then back on, TC system will default on.
- An intermittent connection at VSS or PCM may cause code to set. Inspect harness and all related connections. Check for damage or pushed out terminals. Prior to replacing PCM check for updated software for PCM (reprogrammable).
- Ensure harness is not routed too close to hot exhaust components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.