Code 62, Gear Switch Error: Notes

1994 Chevrolet Cavalier Z24, 2D Coupe, StandardSECTION Notes

The 2nd gear switch should be open in 2nd and 3rd gears. PCM uses this signal to disengage TCC when downshifting.

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. Scan testers display switch status in different manners. Refer to manufacturer operating manual to determine proper status display. Because both switches should be in same state during this test, tester should display same status for both 2nd and 3rd gear switches.
  2. Determines whether switch or signal circuit is open. Circuit can be checked for an open by measuring voltage at TCC connector. Reading should be about 12 volts.
  3. Because switches should be grounded in this step, disconnecting TCC connector should cause scan tester to change status.
  4. Switch status should change when vehicle shifts into 2nd gear.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.