Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 55, Fuel Lean Monitor: Notes
PCM is capable of determining if fuel system can deliver adequate fuel during power enrichment (heavy acceleration). During power enrichment conditions, PCM expects to see both O2 sensors registering rich. If both sensors do not register rich, Code 55 will set.
- Code 55 will set if PCM detects lean O2 sensor voltage for 8 seconds during power enrichment. This checks for proper fuel pressure.
- Restricting the fuel line allows fuel pressure to build to greater than regulated pressure (greater than 47 psi). DO NOT allow pressure to exceed 60 psi.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.