Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1994ASTRO VAN CARGO, 4.3 W, RWDREPAIR AND DIAGNOSISSTEERINGSTEERING COLUMNTORQUE SPECIFICATIONS
1994 Chevrolet Astro Van Cargo, 4.3 W, RWD
Torque Specifications
1994 Chevrolet Astro Van Cargo, 4.3 W, RWDSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Lower Intermediate Shaft Bolt | ||
| Astro, Safari & Van | 30 (41) | |
| Commercial Van Except Motorhome | 75 (102) | |
| Motorhome | 33 (45) | |
| Lumina APV, Silhouette & Trans Sport | 35 (47) | |
| Steering Column Support Bracket Bolts | ||
| Commercial Van | 18 (25) | |
| Lumina APV, Silhouette & Trans Sport | 21 (29) | |
| Van | 15 (20) | |
| Steering Column Support Brace Nuts (Van) | 22 (30) | |
| Steering Column Support Bracket Nuts (Van) | 15 (20) | |
| Steering Gear Mounting Bolts | ||
| Astro, Safari, | 55 (75) | |
| Commercial Van | 66 (89) | |
| Van | 66 (89) | |
| Steering Wheel Retaining Nut | 30 (41) | |
| Upper Intermediate Shaft Bolt/Nut | ||
| Astro, Safari & Van | 30 (41) | |
| Commercial Van Except Motorhome | 75 (102) | |
| Motorhome | 33 (45) | |
| Lumina APV, Silhouette & Trans Sport | 35 (47) | |
| INCH Lbs. (N.m) | ||
| Column Housing Cover Screws | 80 (9.0) | |
| Dimmer Switch Screw | 35 (4.0) | |
| Gearshift Lever Bowl Assembly-To-Column Housing Screws | 18 (2.0) | |
| Housing Cover End Cap Screw | 18 (2.0) | |
| Ignition Switch Screw | 35 (4.0) | |
| Interlock Solenoid Screws | 35 (4.0) | |
| Intermediate Shaft Shield Screw | 53 (6.0) | |
| Lock Cylinder Screw | 30 (3.4) | |
| Shaft Lock Bolt Spring Screw | 35 (4.0) | |
| Shift Lever Gate Screws | ||
| Standard Column | 44 (5.0) | |
| Tilt Column | 33 (3.7) | |
| Steering Column Housing-To-Steering Column Screws | 47 (5.3) | |
| Switch Actuator Pivot Pin | 27 (3.0) | |
| Turn Signal Actuator Arm Screw | 20 (2.3) | |
| Turn Signal Switch Screws | 30 (3.4) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.