Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 32 - EGR Circuit Error - "G" Series: Notes
PCM operates the normally-opened solenoid to control the EGR valve. By providing a ground path, the PCM energizes the solenoid allowing vacuum to pass to the EGR valve. During normal operation, the PCM compares EGR duty cycle signal with EGR control pressure/BARO signal and makes adjustments in duty cycle accordingly. If there is a difference in the PCM command and what is sensed by the EGR control pressure/BARO sensor, PCM makes minor adjustments to correct. DTC 32 will set when:
- RPM is greater than 506.
- No DTC 31 0r 33 is stored.
- 50 kPa difference between desired EGR and EGR pressure for 25.5 seconds.
PCM will default to shut down the EGR.
- This step determines if DTC 32 is the result of a hard failure or an intermittent condition.
- This step checks vacuum at EGR vent solenoid.
- This step checks the EGR valve.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.