Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 47 - IAT Sensor Circuit Low (High Temperature Indicated): Notes
Intake Air Temperature (IAT) sensor is a thermistor that controls signal voltage to PCM. When the air is cold, sensor resistance is high, and PCM will sense a high signal voltage. As air warms, sensor resistance becomes less and voltage drops. DTC 47 will set when:
- Engine coolant temperature is less than 100°F (38°C).
- Intake air temperature is greater than 205°F (96°C) for 2 seconds.
PCM will default to poor engine performance during cold operation.
- This step determines if DTC 47 is the result of a hard failure or an intermittent condition.
- This step determines if the IAT signal circuit is shorted to ground.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.