Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993SPORTVAN G30, VAN PASSENGER, 7.4 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 23 (ENGINE CONTROLS - TESTS W/CODES - 6.5L DIESEL)DTC 34 - INJECTION TIMING STEPPER (ITS) MOTOR CIRCUIT FAULTNOTES
1993 Chevrolet Sportvan G30, Van Passenger, 7.4 N
DTC 34 - Injection Timing Stepper (Its) Motor Circuit Fault: Notes
1993 Chevrolet Sportvan G30, Van Passenger, 7.4 NSECTION Notes
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
The PCM controls injection timing with the injection timing stepper motor. To increase injection timing the PCM extends the stepper motor. To retard timing the PCM retracts the stepper motor. DTC 34 will set when:
- Engine operating at steady RPM.
- A 5 degree difference exists between measured and desired injection timing for 20.8 seconds.NOTE: Test numbers refer to numbers on diagnostic chart.
- This step determines if DTC 34 is the result of a hard failure or an intermittent condition.
- This step checks for an open or short in the ITS coil 1 low circuit and the ITS coil 1 high circuit.
- This step checks for an open or short in the ITS coil 2 low circuit and the ITS coil 2 high circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.