Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993SPORTVAN G30, VAN PASSENGER, 7.4 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ENGINE CONTROLS - TESTS W/CODES - 7.4L)TROUBLE CODE CHARTSCODE 44, LEAN EXHAUST INDICATIONNOTES
1993 Chevrolet Sportvan G30, Van Passenger, 7.4 N
Code 44, Lean Exhaust Indication: Notes
1993 Chevrolet Sportvan G30, Van Passenger, 7.4 NSECTION Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, 1994 GMC Rally Camper Special, and 1994 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
Sensor acts like an open sensor circuit and produces no voltage when exhaust temperature is less than 600°F (316°C). An open sensor circuit or cold sensor causes "open loop" operation.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- Code 44 sets when O2 sensor signal remains low for a precalibrated period and system is operating in "closed loop".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.