Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing Fault Codes
Turn ignition on. Using a jumper wire, connect DLC terminal "H" to terminal "A" for 2 seconds. Remove jumper wire for one second. Again, jumper DLC connector terminal "H" to "A" for 2 seconds. Remove jumper wire. Fault codes are cleared when ANTILOCK and BRAKE lights illuminate, then turn off. Turn ignition off. Check to verify codes are cleared. See RETRIEVING CODES.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.