Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993CAVALIER Z24, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SYSTEM/COMPONENT TESTS - 4-CYLIGNITION SYSTEMTIMING CONTROL SYSTEMSKNOCK SENSOR (KS) SYSTEM WITH KS CONTROLLER (C-5)
1993 Chevrolet Cavalier Z24, 2D Convertible, Standard
Knock Sensor (KS) System With KS Controller (C-5)
1993 Chevrolet Cavalier Z24, 2D Convertible, StandardSECTION Knock Sensor (KS) System With KS Controller (C-5)
- An open or short circuit on the KS wire to the ECM will cause a loss of the 12-volt KS controller signal. This will cause the ECM to fully retard ignition timing.
- If a scan tester is available, connect it to the ALDL connector. Tap on engine next to knock sensor and note "knock" parameter. Knock should be indicated on scan tester.
- If a scan tester is not available, connect a DVOM to the ECM ESC signal terminal. With engine idling, 12 volts should be present at this terminal. Using a metal object, tap on engine close to knock sensor. Voltage signal at ECM terminal should drop to zero volts, and return when knock signal ceases.
- If signal does not respond as described, check knock sensor signal to KS controller. On vehicles equipped with automatic transmission, it may be necessary to place transmission in Drive for timing change to occur. Also, see KNOCK SENSOR (KS) under ENGINE SENSORS & SWITCHES .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.