Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1993ASTRO VAN M V6-262 4.3L VIN ZREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLEDESCRIPTION AND OPERATIONCONTROL SIGNALS - OUTPUTSDESIRED PRESSURE CONTROL
1993 Chevrolet Astro Van M V6-262 4.3L VIN Z
Desired Pressure Control
1993 Chevrolet Astro Van M V6-262 4.3L VIN ZSECTION Desired Pressure Control
This value represents the desired pressure control solenoid current. The desired current is determined from the fluid pressure switch assembly, transmission fluid temperature, transmission output speed, solenoid state, TCC, A/C status, engine speed, TCC slip, and the throttle position sensor. The desired pressure control solenoid current is then used to control the transmission line pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.