Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cruise Control Switch: Resume/ACCEL
To resume set speed after system has been disengaged by braking, momentarily engage and release RESUME/ACCEL switch. Vehicle will return to set speed. If RESUME/ACCEL switch is engaged for more than one second, vehicle will begin to accelerate. To accelerate using cruise control system, engage and hold RESUME/ACCEL switch until desired speed is reached.
To increase speed by one-MPH increments during engaged cruise, tap RESUME/ACCEL switch (quickly move to RESUME/ACCEL position and release). Vehicle speed will increase one MPH for each tap of the switch. After 10 taps, system must be reset to a new speed to continue this function.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.