SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992RV CUTAWAY 5.7 KREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSOVERHAUL & TESTING - 700-R4/4L60TRANSMISSION REASSEMBLYEXTENSION HOUSING
1992 Chevrolet RV Cutaway 5.7 K

Extension Housing

1992 Chevrolet RV Cutaway 5.7 KSECTION Extension Housing
  1. Install speedometer gear and retaining clip on output shaft. If output shaft has 2 locating holes, use hole nearest yoke on Corvette only. Install "O" ring in output shaft sleeve.
  2. Using Seal Installer (J-25016), install output sleeve on output shaft. DO NOT  position output sleeve past machined surface of output shaft. Install seal ring on extension housing.
  3. Position extension housing on transmission case with speedometer bore on governor side of case. Install retaining bolts. Tighten bolts to specification. Using Seal Installer (J-21426), install oil seal in extension housing.
  4. Install speedometer driven gear and fitting assembly. Install retainer and bolt. Tighten bolt to specification. See TORQUE SPECIFICATIONS  . Install outside electrical connector and manual shift lever.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.