Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disassemble
1992 Chevrolet G 30 Van V8-350 5.7LSECTION Disassemble
1. Remove spiral snap ring and discard. A new spiral snap ring must be used every time it is removed.
2. Remove clutch retainer and race.
3. Remove sprag assembly.
4. Remove snap ring, direct clutch backing plate, clutch plates and dish plate.
5. Remove snap ring using spring compressor tool No. J-23327 and mechanical press adapter tool No. J-25018-A or equivalents.
6. Remove spring, retainer assembly and piston.
7. Remove inner and outer seal from piston and center seal from housing.
8. Clean all components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.