SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CORVETTE BASE, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSTARTING SYSTEMON-VEHICLE TESTINGIGNITION SWITCH TEST
1992 Chevrolet Corvette Base, 2D Coupe, Standard

Ignition Switch Test

1992 Chevrolet Corvette Base, 2D Coupe, StandardSECTION Ignition Switch Test
NOTE: For an "engine not cranking" condition with A/T, determine if condition exists in both Park and Neutral positions. If condition occurs in one position and not other, a more probable cause is a faulty neutral start switch.

Test ignition switch operation by rotating cylinder/key through all switch positions. Movement should feel smooth with no sticking or binding. The cylinder/key should return from the START position back to the RUN position without assistance. Inspect and repair if necessary.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.