Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CORVETTE BASE, 2D COUPE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTI-LOCK BRAKE SYSTEM
1992 Chevrolet Corvette Base, 2D Coupe, Standard
Anti-Lock Brake System
1992 Chevrolet Corvette Base, 2D Coupe, StandardSECTION Anti-Lock Brake System
- Anti-Lock Brake Safety Precautions
- Description
- Operation
- Service Precautions
- Bleeding Brake System
- Diagnosis & Testing
- Diagnostic Charts
- Abs/ASR Functional Check
- Chart A - Service Abs Indicator On With No Codes Set
- Chart B - Service Abs Indicator Inoperative Or Flickers
- Chart C - Service ASR Indicator On With No Codes Set
- Chart D - Service ASR Indicator Inoperative
- Chart E - Abs Active Indicator Always On
- Chart F - Abs Active Indicator Inoperative
- Chart G - ASR Active Indicator On With No Codes Set
- Chart H - ASR Active Indicator Inoperative With No Codes Set
- Chart I - ASR Off Indicator Always On
- Chart J - ASR Off Indicator Inoperative
- Code 21 - Right Front Wheel Speed Sensor
- Code 23 - Right Front Wheel Speed Sensor Continuity
- Code 25 - Left Front Wheel Speed Sensor
- Code 27 - Left Front Wheel Speed Sensor Continuity
- Code 28 - Wheel Speed Sensor Frequency Error
- Code 31 - Right Rear Wheel Speed Sensor
- Code 33 - Right Rear Wheel Speed Sensor Continuity
- Code 35 - Left Rear Wheel Speed Sensor
- Code 37 - Left Rear Wheel Speed Sensor Continuity
- Code 41 - Right Front Solenoid Valve
- Code 44 - Pilot Valve Solenoid
- Code 45 - Left Front Solenoid Valve
- Code 51 - Right Rear Solenoid Valve
- Code 55 - Left Rear Solenoid Valve
- Code 57 - Cruise Control Output Monitoring
- Code 58 - EBCM Internal Adjuster Assembly
- Code 61 - Pump Motor Or Motor Relay (1 Of 2)
- Code 61 - Pump Motor Or Motor Relay (2 Of 2)
- Code 62 - Tachometer Pulses/VIN P Engine
- Code 63 - Valve Solenoid Relay (1 Of 2)
- Code 63 - Valve Solenoid Relay (2 Of 2)
- Code 64 - Throttle Position Signal (1 Of 2) VIN J Engine
- Code 64 - Throttle Position Signal (2 Of 2) VIN J Engine
- Code 64 - Throttle Position Signal (1 Of 2) VIN P Engine
- Code 64 - Throttle Position Signal (2 Of 2) VIN P Engine
- Code 65 - Adjuster Assembly (1 Of 2)
- Adjuster Assembly Wiring Repair
- Code 65 - Adjuster Assembly (2 Of 2)
- Code 66 - Adjuster Assembly Control
- Code 71 - EBCM Control Module
- Code 72 - EBCM Serial Data Link
- Code 73 - Spark Retard Monitoring
- Code 74 - Low System Voltage
- Code 75 - Lateral Accelerometer Wiring (1 Of 2)
- Code 75 - Lateral Accelerometer Wiring (2 Of 2)
- Code 76 - Lateral Accelerometer Signal (1 Of 2)
- Code 76 - Lateral Accelerometer Signal (2 Of 2)
- Code 83 - Low Brake Fluid Level (1 Of 2)
- Code 83 - Low Brake Fluid Level (2 Of 2)
- Wiring Diagram
- Removal & Installation
- Adjustments
- Torque Specifications
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.