Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CAVALIER VL, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMDIAGNOSISUSING TECH 1SCAN DATA PARAMETERS
1992 Chevrolet Cavalier VL, 4D Sedan, Standard
Scan Data Parameters
1992 Chevrolet Cavalier VL, 4D Sedan, StandardSECTION Scan Data Parameters
Only the parameters listed in SCAN DATA PARAMETERS table should be used when diagnosing ABS. If other data is received, it should not be considered reliable, and Scan tester should be repaired or replaced.
SCAN DATA PARAMETERS
| Scan Position | Unit Displayed | ||
|---|---|---|---|
| ABS Batt Voltage | Volts | ||
| ABS Warning Light | On-Off Flashing | ||
| Brakes Available | Anti-Lock/Base Brakes | ||
| Brake T-Tale CMD | On-Off | ||
| Brake Tell-Tale CMD | On-Off Circuit Open | ||
| Brake Switch | On-Off Circuit Open | ||
| Enable Relay CMD | On-Off | ||
| Front WHL Speeds | MPH-km/h | ||
| Left Front Solenoid | On-Off | ||
| Left Front EMB (1) | Release/Hold | ||
| Left Front Motor Command FWD/REV | Amps | ||
| Left Motor Feedback | Amps | ||
| Right Front Motor Command FWD/REV | Amps | ||
| Right Motor Feedback | Amps | ||
| Rear Motor Command FWD/REV | Amps | ||
| Rear Motor Feedback | Amps | ||
| Rear WHL Speeds | MPH-km/h | ||
| Right Front Solenoid | On-Off | ||
| Right Front EMB (1) | Release/Hold | ||
| Vehicle Speed | MPH-km/h | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.