Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CAVALIER RS, 2D CONVERTIBLE, 3.1 T, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (ENGINE CONTROLS - TESTS W/CODES - 3.3L PFI)PCM/BCM CODE CHARTSCODE 43, ESC ERROR, W/O ESC MODULENOTES
1992 Chevrolet Cavalier RS, 2D Convertible, 3.1 T, Standard
Code 43, ESC Error, W/O ESC Module: Notes
1992 Chevrolet Cavalier RS, 2D Convertible, 3.1 T, StandardSECTION Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1992 Pontiac Grand Am, 1992 Oldsmobile Cutlass Cruiser, 1992 Oldsmobile Cutlass Ciera, 1992 Oldsmobile Achieva, and 1992 Buick Skylark. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Test numbers refer to numbers on diagnostic chart. If an audible knock is heard from engine at idle, repair internal engine problems before proceeding.
- If tapping on engine does not produce a knock signal on "Scan" tester, try tapping engine closer to sensor before proceeding.
- ECM supplies a 5-volt reference signal on knock sensor line. With knock sensor connected, this signal is pulled low to about 2.5 volts. Knock signal, which is an AC signal, rides on this 2.5-volt DC signal.
- This test determines if knock sensor is faulty or if ESC portion of MEM-CAL is faulty.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.