Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1992CAVALIER RS, 2D CONVERTIBLE, 3.1 T, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C COMPRESSOR OIL CHECKINGCHECKING COMPRESSOR OILNIPPONDENSO 10PA17 10-CYLINDERGENERAL MOTORS
1992 Chevrolet Cavalier RS, 2D Convertible, 3.1 T, Standard
General Motors
1992 Chevrolet Cavalier RS, 2D Convertible, 3.1 T, StandardSECTION General Motors
- Slowly discharge system using approved refrigerant recovery/recycling equipment. Remove A/C compressor, and drain compressor oil. Measure amount drained, and discard oil.
- If no leaks exists, add same amount of oil drained plus one additional ounce. If excessive leak exists, remove accumulator, and drain oil. Measure amount drained, and discard oil.
- If amount drained is less than 3 ounces, add 3 ounces. If amount drained is more than 3 ounces, add drained amount. If system components are changed, add specified amount. See 10PA17 COMPONENT REFRIGERANT OIL CAPACITIES (GENERAL MOTORS) table.
10PA17 COMPONENT REFRIGERANT OIL CAPACITIES (GENERAL MOTORS)
| Component | Ounces | ||
|---|---|---|---|
| Compressor | (1) | ||
| Condenser | 1.0 | ||
| Evaporator | 3.0 | ||
| Accumulator | 3.5 | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.