Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 32: EGR System Error 2.8L, 3.1L, 4.3L (S & T), 5.7L (Greater Than 8500 GVWR) & 7.4L: Notes
ECM controls a solenoid that regulates vacuum to the EGR valve. The normally closed solenoid prevents vacuum from passing until it is energized by ECM. A properly operating EGR will directly affect fuel integrator counts. With EGR valve open, integrator counts will be less than without EGR operation. If monitored integrator counts do not change with EGR commanded, Code 32 will set.
ECM checks EGR operation when vehicle speed is greater than 50 MPH, engine vacuum indicates cruise and throttle is steady.
Test Number 1) With ignition on and engine off, solenoid should not be energized or allow vacuum to pass to EGR valve. When test terminal "B" of the ALDL connector is grounded, EGR solenoid should be energized, allowing vacuum to the EGR valve. Vacuum should hold.
Test Number 2) Checks for plugged EGR passages. If passages are plugged, engine may have severe detonation on acceleration.
Test Number 3) SERVICE ENGINE SOON light should also flash while diagnostic terminal is grounded. If it does not this may indicate the Quad-Driver has been damaged by low TCC circuit resistance.
Test Number 4) Vehicle must be driven during this test to produce sufficient load to operate EGR. Lightly accelerating (approximately 1/4 throttle) will produce a large and stable enough reading to determine if ECM is commanding system on.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.