Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990STEP VAN 6.2 J, AUTOMATIC, 3L80-HD/M40REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGBASIC IGNITION SYSTEM CHECKS (GASOLINE)IGNITION COIL POWER SOURCE
1990 Chevrolet Step Van 6.2 J, Automatic, 3L80-HD/M40
Ignition Coil Power Source
1990 Chevrolet Step Van 6.2 J, Automatic, 3L80-HD/M40SECTION Ignition Coil Power Source
- Turn ignition on. Using voltmeter, check voltage between terminal "B" of ignition coil and ground on models with remotely mounted ignition coil.
- On models equipped with integrally mounted ignition coil, check voltage between BAT terminal and ground at distributor. Battery voltage should exist. If not, check for open circuit, blown ignition fuse or defective ignition switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.