Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990LUMINA APV V6-191 3.1LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULSUBASSEMBLY SERVICEFINAL DRIVE & DIFFERENTIALINSPECTION
1990 Chevrolet Lumina APV V6-191 3.1L
Inspection
1990 Chevrolet Lumina APV V6-191 3.1LSECTION Inspection
1. Check final drive for excessive damage.
2. Check final drive endplay as shown. If endplay is not within 0.009 - 0.025 inch; then replace washers (806/807) shown.
3. Check internal gear and sun gear for damaged teeth or bearing surface.
4. Check thrust bearings, sun gear and governor drive gear for damage or wear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.