Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990LUMINA APV V6-191 3.1LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL FLASHERLOCATIONS
1990 Chevrolet Lumina APV V6-191 3.1L
Turn Signal Flasher: Locations
1990 Chevrolet Lumina APV V6-191 3.1LSECTION Locations
Behind I/P, Left Of Steering Column:
Turn Signal Flasher
The turn signal flasher is attached to a clip on the underside of the I/P lower trim pad to the right of the steering column. Merely disconnect the electrical wiring from its terminals and remove the flasher from the clip.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.