Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1990CAVALIER BASE, 4D SEDAN, AUTOMATIC, 125C/MD9REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESREMOVAL & INSTALLATIONCRUISE CONTROL SWITCHINSTALLATION
1990 Chevrolet Cavalier Base, 4D Sedan, Automatic, 125C/MD9
Cruise Control Switch: Installation
1990 Chevrolet Cavalier Base, 4D Sedan, Automatic, 125C/MD9SECTION Installation
Connect new harness to follower wire. Pull harness into column. Align key on turn signal lever with slot in turn signal switch. Push lever in until seated in spring retainer. To complete installation, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.