Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1988SPECTRUM BASE, 2D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)TIRE PRESSURE MONITOR SYSTEM REMINDERTPMS REMINDER RESET - PROCEDURE 14USING SCAN TOOL
1988 Chevrolet Spectrum Base, 2D Hatchback, Automatic
Using Scan Tool
1988 Chevrolet Spectrum Base, 2D Hatchback, AutomaticSECTION Using Scan Tool
- Adjust all tire pressures to the recommended kPa/psi.
- Install the scan tool.
- Turn ignition ON with engine OFF.
- With the scan tool select Special Functions.
- Select TIM Reset.
- Press the Reset soft key.
- Use the scan tool in order to clear the TPM DTC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.