Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1988RV CUTAWAY 6.2 J, 475/M40REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - DIESELTESTINGINJECTORSOPENING PRESSURE TEST
1988 Chevrolet RV Cutaway 6.2 J, 475/M40
Opening Pressure Test
1988 Chevrolet RV Cutaway 6.2 J, 475/M40SECTION Opening Pressure Test
- Open tester shutoff valve 1/4 turn. Slowly depress tester lever and observe gauge. Note pressure at which needle of pressure gauge stops. Some injectors may pop while other injectors may drip (this is not a leak).
- Opening fuel pressure should not fall less than the lowest limit of 1500 psi (105 kg/cm2 ). Replace any injector which does not meet lowest acceptable pressure. Release tester pressure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.