Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987STEP VAN P20, 7.4 W, AUTOMATIC, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (SERVICING - M/T)LUBRICATIONCHECKING FLUID LEVELTRANSFER CASE
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40
Transfer Case
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40SECTION Transfer Case
WARNING: This page does not describe the selected car, but rather 28 other vehicles, including the 1989 GMC Vandura Special, 1989 GMC Vandura, 1989 GMC Value Van, 1989 GMC Suburban, and 1989 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.
Remove filler plug. Check oil level. If level is not up to filler plug opening, add lubricant until it is.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.