Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987STEP VAN P20, 7.4 W, AUTOMATIC, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 31 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL)POWERTRAIN CONTROL MODULE (PCM)NOTES
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40
Powertrain Control Module (Pcm): Notes
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40SECTION Notes
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All vehicles are equipped with either an Electronic Control Module (ECM), Powertrain Control Module (PCM) or Vehicle Control Module (VCM). Unless specifically stated, references to PCM also apply to ECM and VCM equipped vehicles.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.