Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987STEP VAN P20, 7.4 W, AUTOMATIC, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 27 (ENGINE CONTROLS - BASIC TESTING - 6.5L DIESEL)BASIC FUEL SYSTEM CHECKSFUEL SYSTEM PRESSURE TEST
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40
Fuel System Pressure Test
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40SECTION Fuel System Pressure Test
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, and 1994 GMC Rally Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Begin fuel system trouble shooting and diagnosis with fuel system pressure test. Relieve fuel system pressure before disconnecting any components or installing fuel pressure gauge. See FUEL SYSTEM PRESSURE RELIEF under A-7, BASIC FUEL SYSTEM CHECKS (GASOLINE).
- Turn engine off. Disconnect fuel line at inlet to fuel filter assembly. Install low pressure fuel gauge to fuel line.
- Crank or run engine 10-15 seconds. If fuel pressure is not 5.8-8.7 psi (.41-.61 kg/cm2 ), check fuel lines and fuel tank sending unit for restriction. If fuel lines and sending unit are okay, replace fuel pump.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.