Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987STEP VAN P20, 7.4 W, AUTOMATIC, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ENGINE CONTROLS - SYSTEM/COMPONENT TESTS - 6.5L DIESEL)COMPUTERIZED ENGINE CONTROLSCONTROL UNITGROUND CIRCUITS
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40
Ground Circuits
1987 Chevrolet Step Van P20, 7.4 W, Automatic, 400/M40SECTION Ground Circuits
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, and 1994 GMC Rally Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
- Using an ohmmeter, check for continuity to ground on ECM ground terminals. Resistance should be zero ohms. If not, repair open to ground.
- Using a DVOM, touch negative lead of voltmeter to a good ground. Touch positive lead of voltmeter to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If voltmeter reading is greater than one volt, check for open, corrosion or loose connection on ground circuit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.