Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC 61 - Turbo Boost Sensor CKT High: Notes
The PCM sends a 5-volt reference signal to the boost sensor. As manifold pressure changes, the electrical resistance of the boost sensor also changes. By monitoring the sensor output voltage, PCM detects how much pressure is being produced by the turbocharger in the intake manifold. The PCM uses the boost sensor to control turbo boost and fuel at different loads. DTC 61 will set when:
- Boost signal voltage is greater than 3.9 volts.
- RPM is less than 3500. PCM will default to no turbo boost and poor performance.NOTE: Test numbers refer to numbers on diagnostic chart.
- This step determines if DTC 61 is the result of a hard failure or an intermittent condition.
- This step simulates conditions for DTC 62. If the PCM recognizes the change, then the PCM, and the boost signal circuit are okay.
- This step checks for an open in the ground circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.