All Models

1987 Chevrolet Nova Base, 4D Sedan, AutomaticSECTION All Models
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1991 Toyota Tercel, 1991 Toyota Supra, 1991 Toyota MR2, 1991 Toyota Cressida, and 1991 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove air cleaner. Check throttle cable bracket and linkage for looseness or bending. Depress accelerator to wide open throttle position.
  2. Adjust cable housing so distance between rubber boot end and inner cable stopper or paint mark is .04" (1.0 mm). See Fig 1. Tighten lock nut.
  3. For new throttle cables, stopper or paint mark will not be in place. With new cable securely installed in transmission, pull inner cable slightly until resistance is felt. See Fig 2. Stake new stopper or paint a mark as shown.
Fig 1: Adjusting Throttle Cable
G82880Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.