Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987NOVA BASE, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C COMPRESSOR SERVICINGHARRISON A-6 6-CYLINDERCLUTCH ASSEMBLYINSTALLATION
1987 Chevrolet Nova Base, 4D Sedan, Automatic
Clutch Assembly: Installation
1987 Chevrolet Nova Base, 4D Sedan, AutomaticSECTION Installation
- Install clutch coil and snap ring. Install pulley assembly and snap ring. Install clutch plate key in clutch plate, allowing key to protrude about 3/16" out rear of clutch plate.
- Install clutch plate on compressor crankshaft aligning key. Using Clutch Plate Installer (J-9480-B), press clutch plate on compressor to achieve a clutch assembly clearance of .022-.057" 56-1.34 mm). Using spanner, install crankshaft nut and tighten to 20 ft. lbs. (27 N.m). Turn pulley and clutch plate by hand to check for free rotation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.