SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 475/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 67 (REMOVAL & INSTALLATION - M/T)TRANSMISSION REMOVAL & INSTALLATIONINSTALLATION
1987 Chevrolet Hi-Cube 6.2 J, 475/M40

Transmission Removal & Installation: Installation

1987 Chevrolet Hi-Cube 6.2 J, 475/M40SECTION Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1983 Plymouth Voyager, 1983 Dodge Ramcharger, 1983 Dodge Ram Wagon, 1983 Dodge Ram Van, and 1983 Dodge Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install reverse removal procedure. Apply a small amount of high-temperature grease to the pilot shaft bushing in the flywheel and on pinion bearing retainer release bearing sleeve area before installing transmission. See TORQUE SPECIFICATIONS  .
  2. As transmission is installed, engage pinion shaft with clutch disc by slowly turning shaft to engage teeth. DO NOT  allow transmission to hang free once clutch disc has been engaged.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.