Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 475/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (DISC BRAKE SYSTEM & DRUM BRAKE SYSTEM)MODEL IDENTIFICATION
1987 Chevrolet Hi-Cube 6.2 J, 475/M40
Model Identification
1987 Chevrolet Hi-Cube 6.2 J, 475/M40SECTION Model Identification
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
Vehicle model can be identified by fifth character of Vehicle Identification Number (VIN), stamped on metal pad on top of left end of instrument panel, near windshield. See MODEL IDENTIFICATION table.
MODEL IDENTIFICATION
| Series (1) | Model | ||
|---|---|---|---|
| "C" | 2WD Pickup, Sierra & Suburban | ||
| "G" | RWD Van | ||
| "K" | 4WD Blazer, Pickup, Sierra, Suburban & Yukon | ||
| "L" | 2WD Astro & Safari | ||
| "M" | All-Wheel Drive Astro & Safari | ||
| "P" | Commercial Van/Motorhome | ||
| "S" | 2WD Blazer, Jimmy, Pickup & Sonoma | ||
| "T" | Bravada, 4WD Blazer, Jimmy, Pickup, Sonoma, Syclone & Typhoon | ||
| "U" | Lumina APV, Silhouette & Trans Sport | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.