Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 475/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ENGINE CONTROLS - TESTS W/CODES - 5.7L)TROUBLE CODE CHARTSCODE 35, IDLE SPEED ERRORIAC VALVE RESET PROCEDURE
1987 Chevrolet Hi-Cube 6.2 J, 475/M40
IAC Valve Reset Procedure
1987 Chevrolet Hi-Cube 6.2 J, 475/M40SECTION IAC Valve Reset Procedure
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, and 1994 GMC Rally Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition off for 10 seconds. Start and run engine for 5 seconds. Turn ignition off another 10 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.