Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 475/M40REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - TBIOVERHAULREASSEMBLY (MODEL 220)FUEL METER COVER
1987 Chevrolet Hi-Cube 6.2 J, 475/M40
Fuel Meter Cover
1987 Chevrolet Hi-Cube 6.2 J, 475/M40SECTION Fuel Meter Cover
- Install new fuel pressure regulator dust seal into recess of fuel meter body. Install new fuel outlet gasket. Install new fuel meter cover gasket on fuel meter body. Install fuel meter cover.
- Ensure pressure regulator dust seal and gaskets are in place. Apply thread locking compound (supplied in service kit) to cover screws. Install lock washers and screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.