Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 475/M40REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMIGNITION SYSTEM - HEI-EST (TBI MODELS)TESTINGHALL EFFECT SWITCH TEST
1987 Chevrolet Hi-Cube 6.2 J, 475/M40
Hall Effect Switch Test
1987 Chevrolet Hi-Cube 6.2 J, 475/M40SECTION Hall Effect Switch Test
NOTE:
Hall Effect switches cannot be checked with an ohmmeter.
- Disconnect 3-wire connector at Hall Effect switch. Connect a 12-volt battery and voltmeter to switch terminals. See Fig 1. Carefully note polarity markings.
- Insert knife blade between magnet and Hall Effect switch. See Fig 1. Voltmeter should read within .5 volts of battery voltage. With knife blade removed voltmeter should read 0-.5 volts. If voltage readings are not as specified, replace Hall Effect switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.