SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987HI-CUBE 6.2 J, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (ENGINE CONTROLS - THEORY & OPERATION - GASOLINE)COMPUTERIZED ENGINE CONTROLSPOWERTRAIN CONTROL MODULE (PCM)MEMORIES
1987 Chevrolet Hi-Cube 6.2 J, 400/M40

Powertrain Control Module (Pcm): Memories

1987 Chevrolet Hi-Cube 6.2 J, 400/M40SECTION Memories
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

PCM uses 5 types of memory:

  • Read Only Memory (ROM) 

ROM is programmed information which only PCM can read. The ROM program cannot be changed. If battery voltage is removed, ROM information is retained.

  • Random Access Memory (RAM) 

RAM is the scratch pad for the CPU. Data input, diagnostic codes and results of calculations are constantly updated and temporarily stored in RAM. If battery voltage is removed from PCM, all information stored in RAM is lost.

  • Programmable Read Only Memory (PROM) 

PROM is factory programmed engine calibration data which "tailors" PCM for specific transmission, engine, emission, vehicle weight and rear axle ratio application. The PROM can be removed from PCM. If battery voltage is removed, PROM information is retained.

  • Calibration Package (CALPAC) 

Some models use a PROM and a CALPAC. CALPAC provides fuel delivery back-up so engine runs in case of PROM or PCM failure. Any time PCM is replaced, PROM and CALPAC must both be installed into replacement PCM. If battery voltage is removed, CALPAC information is retained.

  • Memory Calibration (MEM-CAL) 

Some vehicles may use a PCM containing a MEM-CAL unit. This assembly contains functions of PROM and CALPAC. If power to PCM is removed, MEM-CAL information is retained. MEM-CAL also contains an internal ESC module on models equipped with ESC.

NOTE: Components are grouped into 2 categories. The first category is INPUT DEVICES, consisting of components which control or produce voltage signals monitored by the control unit. The second category is OUTPUT SIGNALS, consisting of components controlled by the control unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.