Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1987CHEVY VAN G30, 5.7 K, 400/M40REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 64 (SERVICING - M/T)LUBRICATIONSERVICE INTERVALSSHIFT LINKAGE
1987 Chevrolet Chevy Van G30, 5.7 K, 400/M40
Shift Linkage
1987 Chevrolet Chevy Van G30, 5.7 K, 400/M40SECTION Shift Linkage
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1989 Dodge Ramcharger, 1989 Dodge Ram Wagon, 1989 Dodge Ram Van, 1989 Dodge Pickup, and 1989 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Gearshift control mechanism should be lubricated every 2 years or 22,500 miles. Lubricate if shift effort or noise is apparent. The 4-speed gearshift linkage has a grease fitting located on left side of mechanism.
- Use a high pressure grease gun to lubricate linkage with multipurpose grease, until grease is visible on operating levers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.