Scan Tester - Test Data Parameters

1987 Chevrolet Caprice Classic, 4D WagonSECTION Scan Tester - Test Data Parameters
NOTE: Information in the following table is typical readings taken on vehicle with engine idling, upper radiator hose hot, closed throttle, transmission in Park or Neutral, "closed loop" status achieved and all accessories off (except as noted in tables). Data parameters are updated every 1 1/4 seconds. On systems using P-4 computers, parameter updates are virtually instantaneous. Not all devices & systems are used on all models.
THROTTLE BODY INJECTION

Tester Position Units Measured Nominal Data Value
A/C Clutch On/Off Off (On with A/C)
A/C Request Yes/No No/Yes (with request)
AIR Divert Sol. On/Off On (air to switching sol.)
AIR Divert Sol. On/Off Off (air to atmosphere)
AIR Switching Sol. On/Off On (to exhaust manifold)
AIR Switching Sol. On/Off Off (to catalytic converter)
BARO Volts 3-4.5
Battery Voltage Volts 13.5-14.5
Block Learn Counts 118-138 (128 normal)
Brake Switch On/Off On when engaged
Canister Purge Sol. On/Off On/engine cold (idle some)
Clear Flood On/Off ***See tester manual**
Coolant Fan On/Off Off below 216°F (102° C)
Coolant Temp. °C 85-105° (norm.temperature)
Crank RPM RPM 100-900
Cross Counts Counts 0-255
Cruise Cont. Sw. On/Off when engaged
EGR Solenoid On/Off On when energized
EGR Duty Cycle 0-100% 0/closed-100/fully open
Fan Relay On/Off On when energized
Fan Request On/Off On with request
Fuel Backup Yes/No Yes when engaged
IAC Counts 0-50
Ignition/Crank On/Off On with ignition/crank
Injector Pulse Width Mil./Sec .8-3.0
INT (Integrator) Counts 110-145 (128 normal)
Knock Retard (ESC) Counts 0-255
Knock Signal Yes/No Yes when knock exists
MAT Temperature °C 10-90°
MAP Volts 1 (idle)to4.5(WOT)
Open/Closed Loop Status Ol/Cl Closed/Open during extended idle
O2 Sensor Millivolts 100 (lean) to 999 (rich)
P/N Switch P/N/RDL Park/Neutral
P/S Switch Norm/Hi Normal
PROM I.D. PROM # Original factory number
RPM RPM Spec. +/-25 RPM Drive (Auto.)
RPM RPM Spec. +/-50 RPM Neut. (man.)
Spark Advance # Of Deg. Varies
TCC On/Off Off (On with command)
TPS Volts 1.25 (idle) to 5.0 (WOT)
Throttle Angle 0-100% 0 (idle) to 110 (WOT)
Trouble Codes Code # No Codes
Turbo Boost On/Off On when activated
Upshift Light (Man. Trans.) On/Off Off
VSS MPH 0-actual
3rd Gear Switch On/Off On/3rd & 4th gear
4th Gear Switch On/Off On/4thgear
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.