Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986STEP VAN P20, 6.2 J, AUTOMATIC, 475/M40REPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONCLUTCHESREMOVAL & INSTALLATIONCLUTCH PEDAL ASSEMBLYREMOVAL
1986 Chevrolet Step Van P20, 6.2 J, Automatic, 475/M40
Clutch Pedal Assembly: Removal
1986 Chevrolet Step Van P20, 6.2 J, Automatic, 475/M40SECTION Removal
- Disconnect negative battery cable. Remove cotter pin, washer, and wave washer. Disconnect pedal rod and bushing. Note position on clutch/start switch and remove from pedal.
- Remove nut, spring washer, bolt, and washer. Remove arm and washer. Disconnect clutch pedal return spring. Insert dummy shaft through support and brake pedal to push clutch pedal out and hold components in place. Remove bushings.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.