Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1986CAVALIER RS, 2D HATCHBACK, 2.8 W, AUTOMATICREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER STEERING GENERAL SERVICINGLUBRICATIONREFILLING & BLEEDING SYSTEM
1986 Chevrolet Cavalier RS, 2D Hatchback, 2.8 W, Automatic
Refilling & Bleeding System
1986 Chevrolet Cavalier RS, 2D Hatchback, 2.8 W, AutomaticSECTION Refilling & Bleeding System
- Fill pump reservoir to proper level. Start engine and run momentarily. Stop engine and recheck fluid level. Add fluid (if necessary). Repeat procedure until fluid level remains constant after running engine.
- Raise and support vehicle so front wheels are off ground. Start engine. Turn steering wheel from side to side several times (without hitting stops). DO NOT hold wheel in full left or right position. Fluid level should remain above pump inlet in reservoir.
- Return wheels to center position and operate engine for 2-3 minutes. Road test vehicle and recheck fluid level. Fluid containing air will have a milky appearance. All air should be eliminated to obtain normal steering.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.