Fuel System - E85 Fuel Usage Precaution

1986 Chevrolet C 10 P/U 2WD V8-350 5.7LSECTION Fuel System - E85 Fuel Usage Precaution
Bulletin No.: 06-06-04-035A

Date: February 05, 2008

INFORMATION

Subject:
Use of E85 Fuels in Vehicles Not Certified by GM as being FlexFuel Compatible / Aftermarket Conversion of Vehicles to Operate on E85 Fuels

Models:
2008 and Prior GM Passenger Cars and Trucks NOT FlexFuel (E85) Compatible (including Saturn)
2008 and Prior HUMMER H2, H3
2005-2008 Saab 9-7X

Supercede:

This bulletin is being revised to add model years. Please discard Corporate Bulletin Number 06-06-04-035 (Section 06 - Engine/Propulsion System).

Aftermarket Conversions of Vehicles to Use E85 Fuels

General Motors has become aware of several companies that claim to be able to convert vehicles equipped with gasoline engines to be compatible with E85 Fuels.

Vehicles certified by GM as being FlexFuel (E85) compatible contain numerous calibration and component differences that are not conducive to an aftermarket retrofit.

General Motors DOES NOT support or endorse conversions that may alter the emissions and related emissions components of its vehicles.

Repairs that may result from changes to GM built components and repairs that result from the use of improper fuel such as the use of gasoline containing more than 10% Ethanol in a non-FlexFuel certified vehicle are not covered under the terms of the New Vehicle Warranty.

E85 Compatible Vehicles





The only E85 compatible vehicles produced by General Motors are shown above.





Disclaimer
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.