Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985FORWARD CONTROL 6.2 J, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSOVERHAUL - THM 400TESTINGCONTROL PRESSURE CHECK
1985 Chevrolet Forward Control 6.2 J, Standard
Control Pressure Check
1985 Chevrolet Forward Control 6.2 J, StandardSECTION Control Pressure Check
- Install 0-300 psi (0-21 kg/cm2 ) Pressure Gauge (J-5907) at pressure take-off point at left side of transmission to rear manual lever. See Fig 1. Place gauge where it can be seen from driver's seat. Connect tachometer to engine.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.