Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 32 - EGR Loop Error
Under normal operating conditions, the ECM compares EGR duty cycle signal with absolute pressure signal indicated by MAP sensor. If MAP sensor signal is different from that calculated by the ECM (based on EGR duty cycle) for 10 seconds or more, a Code 32 will set and the ECM will shut down EGR.
- Checks to determine if Code 32 can reset.
- If Diagnostic Circuit Check indicated Code 32, there is probably a minor vacuum leak in the vacuum circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.