Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G20, 6.2 C, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONMANUAL TRANSSERVICING - M/TADJUSTMENTSSHIFT LINKAGEALL WITH COLUMN SHIFTER
1985 Chevrolet Chevy Van G20, 6.2 C, Standard
All With Column Shifter
1985 Chevrolet Chevy Van G20, 6.2 C, StandardSECTION All With Column Shifter
- Place gear selector lever in reverse position. Turn transmission shift lever fully clockwise to forward stop. Turn ignition switch to "LOCK" position. Attach primary shift rod to column shift lever with retainer.
- Slide swivel on to end of shift rod and insert swivel into transmission shift lever. Loosely assembly with bolt and washer. Turn column shift lever sown as far as possible and tighten bolt.
- Turn ignition switch to "UNLOCK" position and move gear selector lever to neutral. Turn transmission shift lever and cross shaft lever clockwise to full forward positions, then back 1 detent to Neutral.
- Align gauge holes in column shift levers (3) and insert 1/4" gauge pin through holes. Repeat adjustment procedure with secondary shift rod. Remove gauge pin and check for proper linkage operation. Ignition switch should turn to "LOCK" position with shifter in reverse only.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.