Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G20, 6.2 C, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 32 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL)FUEL SYSTEM (DIESEL)WATER-IN-FUEL WARNING LIGHT
1985 Chevrolet Chevy Van G20, 6.2 C, Standard
Water-In-Fuel Warning Light
1985 Chevrolet Chevy Van G20, 6.2 C, StandardSECTION Water-In-Fuel Warning Light
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel filter should be drained every 5000 miles, or when WATER-IN-FUEL warning light comes on. Diesel fuel can damage asphalt and painted surfaces. Always place a drain pan under drain hose to collect fuel.
- Stop vehicle and turn engine off. Apply parking brake. Remove fuel tank cap. Open water drain valve 2-3 turns. Start and allow engine to idle for 2 minutes or until clear fuel is observed. Turn engine off and close water drain valve.
- Install fuel tank cap. If WATER-IN-FUEL warning light comes on after driving a short distance, or if engine runs rough or stalls, a large amount of water may be present in fuel tank. Purge fuel system. See PURGING FUEL SYSTEM under FUEL SYSTEM (DIESEL).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.